After sending the calibration command, I put the ADS in short-circuit mode and performed some acquisitions to check the calibration. The measured values are not very ...

I need to operate a 4x4 matrix to find its inverse in my firmware. I was trying to see if there was a function from any TI library can be used for that. So far, I haven't found any. 1. Please confirm ...

I m trying to connect LP-MSPM0G3507 eval board by using xds110-et on board debugger but when i connect to board to pc , i m getting this error attached ...

Could you please refer this thread https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1420924/j784s4xevm-request-for-cpu-load-testing-script ...

Hello, my device is of HSSE type. R5 was previously developed under version mcu_plus_sdk_am62x_08_06_00_18. The compiled firmware will finally be signed by the ...