After sending the calibration command, I put the ADS in short-circuit mode and performed some acquisitions to check the calibration. The measured values are not very ...

I need to operate a 4x4 matrix to find its inverse in my firmware. I was trying to see if there was a function from any TI library can be used for that. So far, I haven't found any. 1. Please confirm ...

I m trying to connect LP-MSPM0G3507 eval board by using xds110-et on board debugger but when i connect to board to pc , i m getting this error attached ...

Could you please refer this thread https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1420924/j784s4xevm-request-for-cpu-load-testing-script ...

Hello, my device is of HSSE type. R5 was previously developed under version mcu_plus_sdk_am62x_08_06_00_18. The compiled firmware will finally be signed by the ...

But it throwed me an error like, Cannot call method "setString" of undefined. Is the syntax correct or is there is any other way to do it? Could you please help me ...

When customer doing short-circuit test, find the device will be damaged and gate pin has no output. It can be solved by add a 200ohm resistor in series on IN pin. Could you please help provide a ...

The difference between case 1 and case 2 with open circuit output lies in whether the output capacitance is large or small. How to determine whether the output capacitance is large or small, and is ...

I'm part of a research group at the University of California, and we're looking to mount a radar on a drone to collect data. Right now, we are using AWR1843BOOST along with DCA1000EVM. We have set up ...

My customer is using an MCU as host of CC2642 to download image to it. In a particular case, for example CC2642 flash is not empty but ROM bootloader is not enabled, the MCU cannot access the ROM ...

Schematic access link: https://www.ti.com.cn/cn/lit/zip/sprr466，the pcb name of the board is PROC154E3, we changed the order of the GPIOs on the expander based on ...

I have two different model development boards design by MYIR. I have two based on a 6254 (4 procs) and two based on 6252 (two procs). (so 4 total) They are identical otherwise. I have built my own ...